|
|
 Because no one is perfect,...  Because no one is perfect, JME sends 20 of these pin connectors for the 10 wires used. We did a practice wire just to be sure we had it right. The MSD crimpers we used on the harness can be used here with the right jaws.  We started by plugging all...  We started by plugging all of the JME wires into one side of the connector, then matching them to the American Autowire harness. There were many wires we didn't use from the harness because we aren't using a vehicle speed sensor, and we're bypassing all the idiot lights. We cut them back and put heat shrink over the tips, saving them for later if we change our mind.  JME's matching glovebox door...  JME's matching glovebox door for the '65-66 Mustang accepts all of the original hardware, including the hinge, the limiting strap, and the latch. Don't give those away with your old door!  Here are the JME gauges installed....  Here are the JME gauges installed. They will look much more impressive after we've painted the dash, of course. We'll hook up the senders later when we finish out the engine compartment.
|