|
After cinching down the pillow blocks to 20 lb-ft using the supplied bolts and high-strength Loctite, the sway bar must be centered. To accomplish this, the distance from the end of the pillow block to the end of the sway bar should measure approximately 2.875 inches. Next, the aluminum lock collars must be tightened to 10 lb-ft using medium-strength Loctite to prevent the sway bar from moving from side to side. Finally, Jarvis attached the endlinks to the lower control arms using the supplied 1/2-inch bolts, and torqued them to 70 lb-ft. View Related Article
|
|